close
close

How To Install Sharkbite Fittings On Existing Copper Pipe

th 1275

How To Install Sharkbite Fittings On Existing Copper Pipe. Be sure the pipe is free of scratches or debris and cut the pipe as cleanly and squarely as possible. Slightly turning the line, push the pipe in the fitting until it reaches the tube stop.

Using Sharkbite Fittings in Plumbing and
Using Sharkbite Fittings in Plumbing and from houseneedssolutions.blogspot.com

The installation of sharkbite fitting into the copper pipe itself is not a difficult task to do however, the hard part appears when you have to do all the measurement work and select the correct fitting according to the size of your pipe. 2 use sharkbite depth deburr gage to mark insert depth. When installing sharkbite fittings always measure and mark any copper pipe that the sharkbite fitting will be sliding onto.

Slightly Turning The Line, Push The Pipe In The Fitting Until It Reaches The Tube Stop.

It needs a smooth surface to seal to. How to install sharkbite fittings to copper pipe now, turn on your water and check the connection. Sharkbites are designed to be used with copper piping.

For Installation, Simply Slide The Sharkbite Onto The End Of The Copper Pipe And Tighten The Clamp Using The Provided Wrench.

Using a rotary tube cutter, cut the pipe so that the ends are square and flush. When installing sharkbite fittings always measure and mark any copper pipe that the sharkbite fitting will be sliding onto. Once the copper pipe bottoms out inside the measuring tool, mark the copper pipe.

When Installing Sharkbite Fittings Always Measure And Mark Any Copper Pipe That The Sharkbite Fitting Will Be Sliding Onto.

3 insert the pipe into the sharkbite fitting. To get started, identify the pipe material. Use your sharkbite deburr & gauge tool to measure and mark the insertion depth on your pipe.make the connection.

Take A Piece Of Copper Pipe And Slide It All The Way Into The Safe Seal Depth And Pipe Deburring Tool.

Connecting a sharkbite joint to a copper pipe 1 cut the copper pipe. Just slide the fittingon to the pipe and slip the fittingback to make the connection. Push the fitting to the insertion mark you just made on the pipe.

Cut The Copper Pipe Such That The Ends Are Clear And Sharp.

Avoid jagged ends with burrs. Copper pipes are very soft and can easily be damaged by the sharp edges of the shark bite. Be sure the pipe is free of scratches or debris and cut the pipe as cleanly and squarely as possible.

Leave a Reply

Your email address will not be published.