Jeep Cherokee Remote Start Not Working. The most common cause for a 2011 jeep grand cherokee remote start not to work is a dead key fob battery. The remote keyless entry system may not function intermittently :
As far as i know, all of the following are met except the battery. I would also check for any codes via predator just in case. Jeep grand cherokee remote start not working.
Discussion Starter · #7 · May 24, 2013.
The heated steering wheel and seats still work, but the ac/heat shuts off when you open the door. This, failure to remote start, went on for a month off and on. The 2015 jeep cherokee has 1 problems reported for remote car start not working.
As Far As I Know, All Of The Following Are Met Except The Battery.
Press the switch down with your finger, and then try to remote start it. The remote keyless entry system may not function intermittently : The first thing to do if you cannot tor, is check on your jeep grand cherokee the first thing that you should check is the battery in the key fob.
Remote Start Abort Message The Following Messages Will Display In The Evic If The Vehicle Fails To Remote Start Or Exits Remote Start Prematurely:
Average failure mileage is 80,000 miles. This disables the remote start when the hood is open. If your battery voltage is too low during the initial crank or your hood switch is acting up it will not work as well.
Climb Into Your Jeep Grand Cherokee With Your Keyless Remote(S) In Hand And Your Manual Ignition Key.
Do not close the driver's door. It is on the side of the engine bay and the hood presses down on it to let the jeep know the hood is down. Check the sensor on the underside of the hood.
Remote Start Not Working Jeep Grand Cherokee Tangerine From Sa10.Eatmytangerine.com.
People have had problems with them sticking and not reading right, and that will cause the remote start to not work. Remote start won't work if the 'check engine' light is on or any doors are ajar. To drive a jeep cherokee after remotely starting it, unlock the vehicle using the remote control.